Search results

  1. L

    WANTED: AFTERMARKET PIPE

    I would like to buy an aftermarket pipe. NO D.G PIPES
  2. L

    BLASTER HEAD MOD

    Could some please tell me if this head is chambered and is it good? It is also milled for premium gas.
  3. L

    Blaster weird engine rattle?

    My 1999 blaster runs good other than a weird noise coming from the engine and first gear being very low. I am very concerned about the noise though. Could someone tell me what it might be? I will make a link to the video of it running.
  4. L

    90 PSI BUT RUNS AMAZING

    My blaster has 90 psi of compression but starts first kick every time and runs and idles perfect. 90 psi is way too low for a blaster. Can my Tester be bad? Or should I just rebuild it? When I got it it supposedly had a brand new cylinder which it looked as so but I’m not sure about piston and rings
  5. L

    Over revved in gear

    So I was going down the road in sixth gear almost full open for half a second then the quad revved to the moon as I pulled the clutch in and put it in fifth gear whilst holding the brake. I shut it off right away then I tried starting it but it only started on choke and acted like it needed to...
  6. L

    Blaster Oil turns milky brown after oil change

    I replaced my oil with 10w-30 650 ml of it because I thought it was burning oil because the level went done after a ride. After running the bike for 5 minutes I checked the oil and it was milky brown. Could this be a case leak? Or bad seal? Also when I run it the oil is below the marks on the...
  7. L

    1999 Yamaha blaster Burns oil HELP

    Ok so picked up this Yamaha blaster that burns oil fast but doesn’t smoke a lot. I think I can smell it. I add oil then run it for five minutes then it’s gone.Could this be the right crank seal? Bike had a new cylinder/top end Starts first kick and has good compression but I’m just worried about...
  8. L

    BLASTER BREAKS

    So I just picked up my Yamaha blaster and the back brakes don’t work. The pads don’t even move the slightest bit when I press the brake. I took it apart and freed the pad but it still doesn’t want to move. Any advice?