Search results

Mine was sounding just like you described but I went ahead anyway and put on FMF pipe and silencer off of used bike I purchased put in a 320 jet from its old carb and it runs perfect screams I don't know why or what I did to fix it. Old 230 jet was spotless. Only thing I can think of is I...

Still wouldn't rev over half throttle But I went ahead and installed the FMF fatty pipe and silencer used Blaster i picked it picked up . then pulled its carb off removed at 320 jet installed on mine it started it up it runs perfect I'm not sure what happened I know the jet that was in it was...

Well?

So.....cut the yellow/black stripe, ground to frame, disconncet harness at carb, disconnect both ends wiring plugs set to brake switch. Done. Is this it?

Well did you figure it out?

Did that fix it? Mine is doing the same thing

Did you fix it?

Well.....did you figure it out?

Also, middle position on needle when I checked it.

False alarm ....idles, starts first kick, everytime. Won't rev past 3/4 throttle bogs to death, why? I have it has the stock 230 jet stock carburetor stock breather lid Oil pump gone, mix 32:1. Nkg, new. Used donor stator was 4 wire.Factory stator had 5 wires one green wire was left...

oh....the leaking in my first post was the caused by exhaust, i had trouble getting it to seal well. i am pretty sure its because i did not remove round gasket on exhaust head first.

ok.....did a leak down test....zero loss.....so back to the puzzle i went......finally decided it was my tors job or carb or stator.........?? which one?? it was the stator....it would not ohm....i had a spare and installed it...and perfection.!! the darn stator all along...

i had just re installed them to help stop the flairing up of reed when tightened, so currently yes

Lmbo, we left the exhaust plug in .....removed it, started 1st kick, still no power, no top end. I guess it's back to leak test and assume it has to be the wet side crank bearing that leaks.

i would like to add....when it was running badly, had zero power and smoked white smoke which stank when under heavy throttle it was running before i removed stator and pulled carb. is there a built in gas filter? inside tank?

2003 blaster started running badly, fouling plugs quickly. i checked compression 120lb in 3 kicks 150 in 5 kicks. i removed the stator to check for leaks, however i did find leaks in my reed block at the top, fixed it. questions...there is tiny gaps at the top of reeds and reed block, i...