Search results

  1. T

    Kick start gear wear

    Hey all, motor has plenty of compression but kick start is not catching. I can get it to catch but only after repeated kicks.. Took cover off and kick start and saw what looks to be a bit of wear? If need be I can upload a better picture later, but I'm wondering if what looks to be wear is...
  2. T

    Stripped oil drain screw

    Stripped my oil drain screw trying to get it out, f@!#$rs in there tight. Any suggestions? Maybe cut a notch for a flathead & visegrips? Channel locks? I have a spare screw just need to get this one out as clean as possible.. thanks
  3. T

    Symptoms of a bad bottom end

    Been going through my blaster lately & was wondering if there's anything I can do to check the bottom end without taking the top end off? Heard if the flywheel moves the bearings are shot? Any ideas appreciated
  4. T

    Holes in exhaust

    I have the stock exhaust and where the pipe meets the motor, follow the exhaust about 12 inches and I have a hole about the size of an auxiliary cord, a little oil stain coming out of it. Will the hole affect performance/jetting in any way? & is the oil normal in that part or could I have a seal...
  5. T

    Intake boot

    The intake boot on my blaster has a liiittle little crack on the bottom of it, do you think I could use gasket sealant & seal it up? It does not leak but I don't wanna wait for the day it starts.. thanks
  6. T

    Jetting for temperature

    Hey all, I have a yamaha blaster stock 230 main jet, stock 32.5 pilot, only about 100 feet above sea level.. I want to know if the average temperature drops about 50F degrees fahrenheit(80-30), how many jet sizes will I have to reduce to compensate(cold air is denser meaning less air meaning I...
  7. T

    Jetting

    Hey all, I know you can't just tell me where I need to be jetted and have it perfect but I just need a base line of like two or three sizes to get and go by. I ordered boyeson 630 power reeds for my stock cage, & would like to pull the airbox lid as well, also thinking about a uni filter. I'm...
  8. T

    Carb leaking

    Hello all, I have a 2001 blaster that's leaking gas out of overflow. Seems to fill up with gas while riding and cause an over rich mixture and causes me to bog on the top end of the throttle. The float does not fill up with gas but where the tab connects with the plastic, has a bit of a...
  9. T

    Runs better with air box lid off

    I have an 01 blaster, I've been trying to figure out a cause to bogging and slow return to idle after throttle blip. When I remove my air box lid I do not bog at all, which means I shouldn't have an an air leak, right? I've replaced throttle cable, cleaned carb many times, adjusted float and...
  10. T

    Bog when wide open only and slow return to idle after rev

    I have a 2001 blaster, 130 psi, injection block off kit, fresh cleaned carb and air filter, fresh 91 octane gas with close to 3 oz of amsoil dominator a gallon, changed tranny fluid, spark plug, air screw between 1.5-2 turns out.. It was running fine last year and all winter as I would give it...