Search results

  1. M

    Jetting problem

    Yes the carb is stock genuine and I bought the jets as genuine and they have the little logo on them
  2. M

    Jetting problem

    Yeah I don’t have that long of a run but I can hold 5th for about 8 seconds with brake applied
  3. M

    Jetting problem

    I have leak tested again today and it held 6 psi for half an hour with not the slightest leak .I have also put a new o ring on the choke to ensure that wasn’t leaking and made sure the injection nipple is sealed well and the air filter boot is good with no cracks. The exhaust system isn’t...
  4. M

    Jetting problem

    hi thanks for your reply, I’m holding it for about 10 seconds with the brakes slightly applied so the motor is working hard, there is no sort of bog at all, the oil injection has been deleted by the previous owner and a tube blocked with silicone has been placed over the nipple and as far as I...
  5. M

    Jetting problem

    I’ve done 2 leak tests and the same results on both not a slight leak any where held 6psi for 10 mins
  6. M

    Jetting problem

    Hi I’ve got a stock motor with a tommey b1 pipe, air box lid off, stock pilot and clip in the middle and I cannot get the jetting right, first I tried the 310 they recommend and on plug chop that was lean I have now worked my way up to a 370 and it is still on the lean side I have leak tested...
  7. M

    Toomey b1 or dmc alien

    Yeah
  8. M

    Toomey b1 or dmc alien

    Thanks for all your help I’ve orderd the Toomey of the website and will order the other jets I’ve done a plug chop before and I’ve alread set the float when I rebuilt the carb just have to wait now for it to arrive
  9. M

    Toomey b1 or dmc alien

    Thanks for your advice think I’m going with the Toomey is the jet that comes with the kit any good for a stock motor with air box lid off and Toomey pipe
  10. M

    Toomey b1 or dmc alien

    Hi looking to get a pipe for my stock blaster but I am stuck between the Toomey and the dmc what are your guys thoughts
  11. M

    Won’t rev past half throttle and smokes loads

    Yeah I can’t seem to figure it out the carb is spotless but when that carb is on the problem happens but if I put my buddies carb on with the same 270 jet it runs perfect
  12. M

    Won’t rev past half throttle and smokes loads

    Still not sorted I’ve orderd a new one carb
  13. M

    Won’t rev past half throttle and smokes loads

    the float level is at 21mm and the air screw is 2 turns out
  14. M

    Won’t rev past half throttle and smokes loads

    Hi got a bit of an update I did the compression test that’s fine at 120 psi but I also tried a carb of another bike and it sorted the problem it has the same jets as mine, so I cleaned mine replaced all the o rings and gaskets inside it and my carb is still doing the same do you have any idea...
  15. M

    Yamaha raptor rear disc

    Hi will a raptor rear disc fit a blaster as need one and all the blaster ones I can find are over seas
  16. M

    Won’t rev past half throttle and smokes loads

    Larry mine didn’t have the tors brain box I saw that the newer ones didn’t have it, thanks for the advice
  17. M

    Won’t rev past half throttle and smokes loads

    Hi the year is a 2005 and I will do a compression test tomorrow
  18. M

    Won’t rev past half throttle and smokes loads

    Hi my Yamaha blaster will idle perfect and run fine in the lower rpm range but as soon as I give it more than half throttle it puts like some sort of limiter on and smoke heavy white smoke I have removed parking brake and tors also new spark plug and cleaned the carb but it is still the same, it...