Search results

Sorry with ot Without the tors

With or with the tors system

You might wanna check your compression

Sounds to me like it could need a rebuild on the top end.

I use belray Gearsaver for wet clutches. Always works well for me

I have a set of plastics but they are the purple ones

I just put a brand new oko 30mm carb with a bunch of jets( i got for free from a buddy) and i have no clue where to start jetting . Right now i have a 150 main and a 50 pilot in it i have to choke it for it to start and when it dose start it wont ideal and when i give it gas it revs ok for a sec...

My Mechanism dose not move at all its a siezed up i think i need a while new mechanism.

Ok thanks

I would like to have the rear brakes

I am i need of some rear brakes for my blaster. I am looking for a rear brake awk Setup or even A functiong stick caliper. I have one but the mechanism inside is totally shot.

Yep what he said

If i were you i would get rid of that oil injection all together and just pre Mix your gas 32:1.

My spark plug was totaly caked with sh*t when i pulled it out but it still ran good just went and got a couple new ones to find out for sure if its too rich.

J just have a k&n filter fmf Full exhaust thats about it i m pretty sure i just got this blaster at the end of last fall so not sure if there are any mods to the motor.

my bad i meant To put 230 just noticed i put 330

What size main jet came stock in the yamaha Blaster 26mm mikuni carb. mine has a 330 in it. It runs pretty good but inthink it might be a little rich..

Yes

I have a new carburetor and auto cable I just haven't put it on yet

I have no rear Brakes right now and my front brakes suck and i cant get the hubs apart on the front to check the shoes. I really want to get set up with some rear hydro brakes anyone have any ideas on that. I would really appreciate it.