Search results

  1. fouchis

    Oil Pump Cover Rubber Grommet

    Is anyone interested in a rubber grommet that goes on the oil pump cover? The OEM part no. is not available anymore HOLDER, OIL PIPE Not Available 10V-13174-00-00 and I thought about contacting a manufacturer to reproduce them without the oil hose holes in them. I found a new one on ebay, but...
  2. fouchis

    Crank specifications

    has anyone reused a crank that was at the high end of the specs .28? If yes, any problems or does anyone recommend just putting in a new one. (Shaft gap)
  3. fouchis

    Need a Special Carburetor Part

    Anyone have some old carbs with this part they would sell? Need two.
  4. fouchis

    Chain roller stud broke (bottom)

    I searched to no luck for this on the forum. My bottom chain roller stud is broke off. Any suggestions or fixes? I have another frame I can cut a top one off of and weld it, but thinking there has to be something easier.
  5. fouchis

    Engine knock reasons?

    Engine is knocking and losing power. Backfired a couple times when trying to start. Hard to start and will not stay running without babysitting. My suspicion is something with timing, but dunno for sure. I continually do Air leak tests. Still good!! Piston, rings and cylinder still look...
  6. fouchis

    New Build Problem

    So I just finished up my son's blaster today and took it out to go through some heat cycles and had a very bad experience. BTW, here is the build and set up. NEw Wiseco crank and piston, bored to 66.50, DG exhaust system, carb- 290 main and air screw out 1.5 turns. Fuel 32:1, new boyesen...
  7. fouchis

    New setup help

    I took a chance and bought a blaster this past weekend for the neighbor kid. After engine break down we noticed it had a .75mm piston (type??) Anyway, after putting it back together and correcting many other problems and performing leak test (passes) we are trying to set the carb up. -FMF...
  8. fouchis

    Major Air Leak--Help

    I have a bad air leak at my intake. Seems to be here. Do I put gasket sealant and try leak test again or buy new intake boot? Going by the book it shows no gasket here between the reed valve assembly and intake boot. Any help appreciated.
  9. fouchis

    Need Parts

    left side crank case will add more and edit later Please PM or email fouchis@yahoo.com
  10. fouchis

    New Blaster Set-up---jetting-needle position-gasmix help

    I'm new to Blasters and looking for a ball park set-up for jetting, needle position, gas-mix, and air box lid(on or off). Here's the mods so far: FMF fatty with power core 2, oil injection delete, K&N air filter, TORS delete - motion pro- using stock carb, Boyesen reeds, altitude 0-2000ft...