Search results

  1. Upbasher

    Any other kick levers that will fit?

    Hey guys, long time, no posts! :) Anyway I need/want a different kickstart lever for my blaster. All the stock ones I have are worn out. (Yes I know you can fix them, Ive done it before lol) I cannnot find any aftermarket ones for blasters anywhere though. Does nobody make a aftermarket lever...
  2. Upbasher

    I need help again Tusk axle

    I just bought a tusk adjustable racing axle.....its nice and shiny and all but I cannot figure out how to get the c clip on the brake disk side on. My blaster is 05 so the two washers go on the outside of the brake hub(If I am reading the instructions right). The problem is with those two...
  3. Upbasher

    Why did my top end go?

    Okay so I just recently rebuilt my blaster. I put all new bearings and did a full top/ bottom rebuild. A few days ago was riding 6th gear at about half throttle and it decided to start seizing up on me. It would run fine for a mile or two if you let it cool but as soon as it got hot it would...
  4. Upbasher

    play in new crank bearings

    Okay so I just rebuilt my whole engine. Was checking the crank and it had a tiny amount of up and down play on the drive gear side. If you grab the drive gear and wiggle it up and down there is a TINY but of play. I mean like so tiny its about the width of a human hair. In fact the only way you...
  5. Upbasher

    How to remove left crank seal with out splitting cases?

    Another question...When I put my engine together I pushed the left side (stator) crank seal below flush with the lip. After persuing the forum and net I discovered that this can potentially cause bearing failure due to starving the bearing of oil. Which makes sense of course cause it make the...
  6. Upbasher

    How cold is too cold for break in?

    I have a freshly rebuild engine top and bottom new bearings piston and everything. My question is how cold is too cold to break it in effectively? I live in Michigan and its about 25 degrees right now. Im very impatient and don't wanna wait till spring. :)
  7. Upbasher

    Help with swingarm seals!

    Im putting in new swingarms bearings and seals, I cannot for the life of me figure out how to get the seals inside the outer cups. I cannot get them to go in there with the washers in. They wont fit in between the washer and the cup like they supposed to. Is there a trick to getting them in there???
  8. Upbasher

    Play in clutch gear

    Okay first time poster here. I just rebuilt my blaster engine top and bottom. I discovered that my clutch basket actually has some play in it on the gear. The gear will spin about a quarter to half an inch on the basket before grapping. Theres no slop in it it just spins some before grabbing. Is...