Search results

  1. Z

    240 Kit Help Please

    Hi All! Thanks for the help. The solution cost under $2! The flywheel keyway was sheered off. We replaced it, and it runs GREAT! Gets a little warmer than I'm used to, but don't usually ride in the summer. Kristin bump
  2. Z

    240 Kit Help Please

    Cycle sports didn't have the jet...we'd rather not buy from Ramsey Waite...what are the other shops??? The ones on West 11th never have anything... As for the new carb...we'll try the bigger jet and original needle because a new carb is pretty expensive... Thanks! Kristin Bump
  3. Z

    89 blaster over reving, and leaking! anyone help?

    My blaster did the same thing when we got it...it had an air leak and was leaking transmission fluid...we pulled the screws and put teflon tape on them and put them back in...no problems now!
  4. Z

    2000 Blaster won't idle

    Have you tried adjusting you idle? It's a little knob under the seat/gas tank... Good Luck... Also, you local yamaha shop will be able to get you a jet...just tell them what has been done to the bike...like if it still has the air box, or if any engine work has been done to it. Also...
  5. Z

    240 Kit Help Please

    Bump Bump puts the thread back up to the top of the forum...I was hoping to get some more ideas... The local shop doesn't have a 390 jet, so we have to wait until one gets here... Is that what we should do? LR Racing says that's WAY to big and it wont work...but his latest idea is that the...
  6. Z

    Blaster vibration

    Mine Too... My blaster vibrates badly too... Not in the low RPM's, but when it's up on the pipe...atleast it did when it ran... I rode my mom's blaster this past weekend, and noticed it did it also, but no where near as badly. Maybe it's something with age??? Mine is a 91 hers is an...
  7. Z

    240 Kit Help Please

    bump bump up to top
  8. Z

    240 Kit Help Please

    Thank you for the quick responses! I beleive we switched out both the reeds and the carb. The reeds from the 2002 blaster had some bars/prongs attatched to them that mine didn't have... When I bought the bike it had already had some engine work done so the previous owner may have changed...
  9. Z

    Having Issues

    Hi Everyone, I'm new the the forum, but not new to the blaster. I've had mine for about 9 years now, and have started riding again consistantly with my boyfriend in the past 3 years. I'm 23 and just graduated from Western Oregon University with a Bachelor's of Science in Earth Science...
  10. Z

    Christmas Valley Dunes?

    Not Good Sorry, I've never been there, but I've heard if you're a coast rider it's not a place for you. Extremely dirty. I like clean sand, so I probably will never go. If you go though, let me know what you think!
  11. Z

    240 Kit Help Please

    Hi Everyone, My dad recently put a Vito's 240 kit in my bike. It included the Head, Cylinder, Piston and Rings. LR Racing did a mild Trail Port or Blueprint on the Cylinder. The 340 main jet, and the included pin are in the carb as recommended by both Vitos and LR Racing. We went...