Search results

Stupid stupid i figured it out.. When i put the bowl cover on it wouldnt let the float close completely...i pulled the floats apart a tiny little bit and put it all back togetjer and it revs up fine.. Thanks everybody for all the suggestions i am going to up the jet for the exhaust thanks again

Damn its the weekend and I wanted to go riding... so I took the Carb and reeds out, pulled the Carb apart and now I am going put it in a sonic tank and maybe its just something dirty... well see

Why would I need to up the jet size if the bikes running to rich as it is

32:1 mix The jet size is stock Air screw is out 1 1/4 full turn

No I don't have to add oil... it only smokes like that when the fuel switch is on.... I also checked it see if the Carb was leaking into the head and it doesn't leak

It doesn't rev up on its own... I rev it and it smokes like a pig and gets stuck at a low rpm... but if I shut off the fuel valve, than it will rev high and the smoke is minimal

This problem has been happening before the Carb rebuild... Float height is 20mm- 21mm

The tors is removed so I have it idled off the cable... I don't have any leaks... only aftermarket part is the fmf exhaust [QUOTE=89blaster89;648521]put all the stock parts back in thee carb, adjust idle, check for airleaks since you rebuilt it, do yo have any aftermarket parts? and since...

I got this blaster in pieces... it came with a new crank with bearings and piston with rings .... so I built the motor and got it running... motor has 150lb compression... I just rebuilt the carb with all new hard parts... sleeve, needle, mixture needle, high speed needle, and etc... The...