There are also wheel spacers that will adapt from one size to another, and you'd gain width, which is always a good thing assuming the rims you're...
I wanted to say "not without the honda hubs" as I'm seeing honda bolt pattern as 4x110 and our blasters are 4x100 but a quick search turned up...
it will run the best .... right before it doesn't plug chops prevent that
This one appears to have the most sold on ebay, but a search will produce a sh*t ton, stay away from any with bedazzled flashy side panels, those...
I have never used ATF fluid, my Driveline performance clutches recommend Mobile 1 10w-30 full synth 4t engine oil, available at walmart and many...
Yes, silencers do not effect jetting, only sound but as with any changes, a plug chop should be done to confirm...
trans fluid is a thinner viscosity than the previous gear saver and the 10w-30w oil the blaster manual recommends, so it's sucking in the bad seal...
https://www.blasterforum.com/threads/adjusting-your-airscrew-pilot-jet.51060/
Most info recommends soaking the clutch plates at least overnight, but they've been sitting in it now for a few days it seems ? have you started...
I can't recall anyone having any luck running a stock carb with a built 240 engine I highly suggest you look into a 35/36mm carb and intake, then...
Did you get the pointer aligned with the notch on the case when adjusting the center rod/nut adjustment ? the cable needs to be off at either end...
What jetting is in the new carb ? float height ? airscrew setting ? we've never found any aftermarket carb that has the slide #, needle/jet or...
You need the 03-06 peg and pedal, or weld an extension onto the 88-02 pedal to run the master cylinder. the 03-06 pedal will not mount to an 88-02 peg
Banshee or any other swingarm will not bolt on without significant fabrication Ebay swingers, use your existing or banshee axle carrier (hydro...
Follow these exactly for your year blaster, just unplugging the carb is not how to delete it ..................
TORS deleted ? https://www.blasterforum.com/threads/how-to-remove-your-tors-88-02-models.655/...
No aftermarket carb comes with the correct jetting for a blaster, none. that includes the slide cutaway #, needle jet, needle, pilot and main....
Time to go full delete and get a TORS removal cap/cable and carb mounted idle screw kit ...............
unburnt vaporized fuel is in the pipe, and the rebound waves of the expansion chamber forces those hot unburnt gasses back into the cylinder as...
You don't need those plugs, those 2 bungs are for the water pump when this bottom end was used for the DT200 engine, they are blocked off by...
Separate names with a comma.
