To delete, or not to delete, that is the question. I am finishing the clutch install now. I figured after all these years there might be a...
Just now seeing this. It took me an hour and a half to figure this out but I got it. I searched everywhere for this. Also for future reference for...
Anyone have tips or tricks to install the rotor? I keep sliding the rotor down the crank shaft but I cannot get it to push on without knocking off...
https://www.blasterforum.com/threads/yamaha-blaster-parts-service-and-owner-manuals-free-download.17325/ Just happen to have that page open.
Yeah If it has rubber bushings mine has none. You are correct on it being loose. I tried to up load a gif and other formats to show the plate...
Thanks Larry. I have all the parts in and going to attempt to complete the bottom. I have run into an issue or maybe not. Is this normal? The...
Still a little confused on the seals? Which one goes on the magneto side and which one goes on the clutch side? Then this vague installation step:...
Anyone that has seen my post knows I bought a 1996 Yamaha blaster yes the ugly duckling yellow purple. I have spent many hours learning about this...
Can you see this one? [MEDIA]
Thanks everyone. I got it. So to assemble the shift forks this is how I did it. Take the drive axle and the main axle place them together and...
I know this is an older post but I thought I would drop this in. Several years ago an acquaintance of mine bent the frame on my 5 month old Suzuki...
Pictures. Lucas oil thickness from the q tip it is very viscus and tacky but oily [not runny as the picture would suggest - more like cold honey]...
So the forks are not in the correct slots? I have cleaned every part by hand (first was a bath in kerosene, dried with a rag, shot with PB,...
I see a lot of great information and videos on engine builds however all of them that I have seen go from next I will install... to OK now that I...
Got it. Thanks Awk08
I have the bearings in. Used the BBQ again. I received two crank seals and unsure on which one goes to what side? I am thinking the black seal...
lower line fuel. Upper line oil. Lower line gas goes to the fuel bowl and upper is where the oil is sucked through the throat with air.
Better with a picture. [ATTACH]
Mine at the cover measures 19.85 mm.
I have my engine broke down right now and I can measure mine. What measurement are you looking for?
Separate names with a comma.
