Are the cables moving freely thru their full range of motion? Did you check the cable block? Think you might not be getting full throw on cables?
Plug chop to confirm your jetting.
Just where the ground wire. Needs to touch bare metal to ground
Bearing stays on shift drum. Still don't remember a washer being used. Probably your problem?
Under the tank where the. Ing coil bolts on
Where are you adjusting at? Wheel or handle bar?
Under the front hood check the block where the cable from the bar goes in and 2 come out make...
Make sure bearing is on all the way.
Blind hole is clean as mentioned above?
It doesn't take much. Small nick in case where bearing rides.
She's looking good
Just remember to sand some of that new paint off for coil ground wire.
Chassis grounds need to be in bare metal.
Sounds like she will have a fun ride.
As for the bolt? If that is what you looked up. Or take one out and and measure the pitch.
Any shoes left...
The locking tabs and nuts are a good idea.
Snap rings for idler gear are supposed to be replaced also. Hows the balancer gear?check to see if it...
I don't remember any washers being used.
Is the hole in the left case. Where the drum goes in left case clean. Nothing in the bottom of the...
Yes that would be #2.Change it if it looks worn. Hows the bearing?
Which side did you split case's from?
Or stator side? Stator side has more of a interference fit on inner race to crank
Also look at fork ends for excessive shiny area on ends. Basically see if one is bent . main shaft may have been moving some
Check the bearing. Does it roll freely? Did outside race spin in case?
It must be flush with the case. Almost looks cocked alittle in pic? Or just...
Break is from the crank area out so I'm voting piston skirt broke off on previous piston. Does the cylinder look like it was bored and new piston?...
Is it flooding? Any gas in the Bowl?
If you are getting spark then the switch should be good as all it does is ground out ignition
Do you have the pieces that broke off?How's the bearings on balance shaft?
That. May have broke also from a piston skirt breakin off previously?...
Those things are bad asz
Separate names with a comma.