Transmission/Clutch Oil questions

bigbuilder

Member
Apr 6, 2021
30
3
39
51
Hello Everyone,

Thank you for letting me join.

My son has bought a blaster and we have been fixing it up.

We installed a new barnett clutch yesterday and it went well. Othr than a stripped bolt.

When we filled it up ( type F) to mid point of the site glass it was quite a bit less than the 650 ml. That was mentioned on this site. It looked like it took about 300 ml to get to that point.

Can anyone comment on it we are missing something?

Thank you.
 
Hi Again, Any thoughts on wheter I should go with the 650 ml or the site glass? Or am I missing something?
 
Yes. I presoaked for 3 minutes per the instructions that came with it. I put in 650 mil. After reading about it on this forum. Thank you,
 
Most info recommends soaking the clutch plates at least overnight, but they've been sitting in it now for a few days it seems ?
have you started and ran it to operating temps then recheck the sight glass ?
fill it with 650ml until the fluid gets dispersed to throughout the trans/cases, then check the glass again