Rebuilt blaster help

Pitcrew

New Member
May 22, 2019
4
0
17
39
Hello guys I recently did a rebuild on a 2002 blaster, did all the necessary things to start the warm up well at idle it revs up fine but when it goes into 1st gear and any gear at that there is no power??? Any suggestions need help thanks
 
Did you do a leak down test? Retorque after heat cycles?
Is the TORS brain box unplugged? 3 wire plug under the hood.
Do you have any mods?
 
No mods, stock.. blaster ran alright before tear down the reason for the rebuild was I was hearing like a Scratching noise towards the bottom left side of so we did a bottom end build put back together and started right up in N I can rev it up but once it goes into gear no power, i push clutch in and rev in gear let go and it will try to catch speed but other then that nothing
 
When it’s in gear is the engine rpm going up Are down when you try and take off cause if the rpm is up you need to adjust the clutch an if the rpm drops then you need to clean your carb that’s my guess bud an also make sure your float is at the right height cause it can cause it to
 
No mods, stock.. blaster ran alright before tear down the reason for the rebuild was I was hearing like a Scratching noise towards the bottom left side of so we did a bottom end build put back together and started right up in N I can rev it up but once it goes into gear no power, i push clutch in and rev in gear let go and it will try to catch speed but other then that nothing
Were new bearings and seals installed on rebuild? And was a leakdown test performed after final assembly.? A leakdown test is very important on these.air leaks can cause engine damage fairly quick