Tors issue

so the other night I deleted the tors on my 03 and it ran mint rode it around let it idle etc...shut the bike off and put it back in the shed it’s now 2 days later I start the bike and it is acting as if the tors is still engaged bike won’t rev..any ideas ? Reeds have been cleaned stator is good because I took it off my running 05 not sure what else it could be?

So today took flywheel off cleaned up the magnets with a little sandpaper ...cleaned reeds again even though they were fine...started the bike it ran good for about a minute revved and idled and then started acting again as if the tors was engaged is this the sign of yet again another bad stator and if so why does my bike keep
Burning stators

Parking break is deleted and yes tors was deleted correctly I did it same as I did on my 05 and that one runs perfect

Thanks will ohm it tomorow swapped out cdi and coil from running bike still didn’t fix the problem...it was weird I deleted tors bike ran mint next day wouldn’t rev so I did what i said in my previous comment above and still can’t get it to run right would any electrical component on the bike possibly be putting out to much or not enough power and shorting out my stators? The bike had a bad stator where it wasn’t getting spark I took the one off my running bike and threw it in here so if this one is bad this will be the 2nd stator I’m going to have to replace