I can't seem to get my clutch installed correctly I lined up the dots for the clutch plate installed the friction plates and everything but I can't get it adjusted correctly I adjust the screw and the clutch lever is hard it won't move and also the plates won't move when I move the clutch lever please help sorry if its confusing
Please help with clutch
- Thread starter heatlbj6
- Start date
so you adjusted the center adjustment rod until teh clutch actuator was pointing at the alighnment point on the cases then locked it in place with the 10mm nut and some thread lock?
Do exactly as scotj77 said and it should work ... You know there's an order in which you must off set /stagger every clutch plate from the last. There are marks/tabs on each plate you can use as a guide for proper offsetting. I believe the manual says every plate must be staggered 60 degrees from the last. If they are not installed right that would cause your clutch to be tight as your describing.
Also you may need to remove both push rods and the ball in between the push rods before installing.g the clutch plates. Push rod #1 is attached to the pressure plate, just so there's no confusion.
Similar threads
