Recent content by ToddsToys

The leak is between the right side seal and the outside of the collar. It's a brand new seal. Should I get a new collar.Or should I put yamabond between seal and collar?

I cannot find this air leak anywhere and it is killing me

I am getting air bubbles in the soapy water from the vent tube so does that mean the crank seals are badd? I just had them installed from a professional dealership I take it this means they screwed up?

So I got the right plug for the exhaust port did the test again and it still reads I have a leak and I cannot find it anywhere how can I tell if my crank seals are not installed correctly? I had them done from a Yamaha dealer in my area

So I did a leak down test today and I am losing about 1.5 per minute and I cannot find a leak anywhere. The plug I used in the exhaust port may not be holding tight enough though so I am going to get a better one and try again.

OK I will do a good thorough check to make sure everything is where you said it needs to be I will get back to you when it is all checked thank you for your advice I really appreciate it

Basically what is happening is it feels like it is bogging out when I 1st get on the throttle but then when I get to higher rpm it kicks in like normal

I am new to the forum, so I would like to 1st say thank you to everyone who has contributed by taking the time to share their knowledge and experience,it has been very helpful for me,and many others I am sure. I have a 2004 blaster with brand new weisco bottom end and top end ,bored out to...