Recent content by roody23

I put a new top end on the bike brand new gaskets piston cylinder I cleaned carb real good tors plugs are cut and I'm getting no response tuning the carb it idles crazy high unless choke is on bogs real bad idk if the tors is making my bike act like this

I but it together I took it for a ride go for a left turn crash right in to the gatr its not locking left wat could it be

Do u still have the plastics

Can u pm me I don't know how 2

300 and I have a regular air filter and the bike mixes its self is 280 still to small

My blaster is bored over to a 67mm bore I bought a fmf pipe for it and I have t6 -5 muffler I have the air box removed I brought a 280 main jet is this large enough and those any one have a flange for the Fmf pipe can't find one on eBay

Blaster smokes like crazy when i put tranny oil in it but wen i drain the oil. It smokes a little i think its letting oil into the crankcase my question is can change the seals with out spliting the case

Awk08 do u still have leaker testers for sell

We're can I get a leak tester or get one done

the blaster starts up nice. but it idles very loud and in high gears its slow and weak it has the lid removed and it has a t6 muffler and stock exhaust everything else stock. the question is were do i start tuning the bike should i change any jets and i also ordered a fmf fatty pipe

Ok thanks ill check my manual

How hard would it b to change the gear rod

I do not know were to find that

Sorry i do not know what splines are new to this but its striped to the point were i can turn it till the case stops me

Im having this problem can i just Weld it or even drill a hole through the lever and rod and add a Bolt and nut because the nut was added already with a longer bolt