Recent content by Jaggerd

Retightened fly wheel and it fixed my issue

I never got instructions...

Could this be the source of a rattle/ knock

I forgot to mention I topped off the tank with brand new pump gas I just bought yesterday 93octane klotz supertechni 25:1 previously at 32:1 93 octane and I was retuning because I switched to the original Mikuni, this time at least. The previous Time it happened with opti:2 32:1 93 octane after...

I still have oem cylinder, it sill has a few sizes left in it I believe, it’s at 67.5 I think but it was blown and I decided on china cylinder, ports are all chamfered and rod and crankcase cleared but I never knew there was a spec

Not so good audio of me kicking it over: Basket play:

I recently rebuilt a 88 blaster with Vito’s 3mm stroker crank and a Chinese top end, my blaster started making a rattling noise after about 3 hours and I thought something came loose under the clutch cover, nope I took it all apart and put it back together, I then thought it was piston slap and...

Would you recommend a kx85 Keihin 28mm carb rather than the knock off ?

I just bought it a week ago and put a Vito crank and new Wiseco top end along with pipe. The old carb was basically trash, rust all over and slide was gouged and scraped up. I run 32:1 with a 28mm pwk knock off. Float height correct and I can’t remember jet sizes I have in it. 40ish idle and...

It makes a pinging noise in the expansion chamber At idle and I’m not sure if this is normal for a blaster. It does not have the same normal 2 stroke ping as other bikes, it’s a lot deeper. And when I’m on the throttle, about 1/4 and below (idle jet) it is always sounding very deep and poppy...