Recent content by haegs09

  1. H

    Is it blown up?

    Argh! Should I expect minimal damage since it still runs?
  2. H

    Is it blown up?

    Was riding my blaster for the first time in a while today. Just went thru everything yesterday, emptied all the old gas, cleaned the carb, changed the plug, etc. After riding for an hour, I did a full throttle run in 6th (didn’t over rev it though) and it just shut off in the middle of the run...
  3. H

    LRD Adjustable w/ Silencer and FMF Fatty w/ Powercore 2

    is the fmf still awailable?
  4. H

    Im so confused......

    i just don't get why it ran perfectly with no issues when it was all stock. Didn't even bog or anything. Now, when it should be lean, it bogs from being too rich. what could any other problems be? Float height is set
  5. H

    Im so confused......

    i just dont understand why it ran fine all stock with a 230 main, then i let more air in and it runs rich one size up. Shouldn't it need more gas to compensate for more air?
  6. H

    Im so confused......

    yep
  7. H

    Im so confused......

    Stock pilot and aircrew 2 turns out. That's where the idle is highest. Needle is stock too
  8. H

    Im so confused......

    I am 600 feet above sea level. I will measure the float height tomorrow
  9. H

    Im so confused......

    So ive made a few threads about my situation but ill say it again. My blaster is all stock except for removed airbox lid and profilter air filter. I was told to jet it at 240-260 and see which in there was best. I tried a 250 and at 3/4 to full throttle it would bog. I got a 240 in there and it...
  10. H

    Please help!!!!!

    Hey awk, so I should set my float height then adjust the air screw? I'm new to messing with quads, so please be as simple as possible while explaining it!
  11. H

    Please help!!!!!

    Filter seems perfect. The washer went in under the jet. I actually didn't set the float level how do I do that?
  12. H

    Please help!!!!!

    The low end was perfect. Its idles fine and I have been changing the air mixture a lot. I have it 1 1/2 turns out right now and it still runs crappy. I will do a plug chop later today.
  13. H

    Please help!!!!!

    Ive been tweaking the air screw with no luck. Its a profilter
  14. H

    Please help!!!!!

    Ok so I was modding my blaster by taking off the airbox lid and putting in a new airfilter. I asked around on here and people said that I should try anywhere from 240-260 jetting. I put in a 250 and I lost a lot of power. The top end and midrange were the same but there was no low end. It barely...