Recent content by Dschade

OK I got it running fine thru out the gears but my problem is that it will take 20-30 kicks and it will start and bog for a few seconds. Once I get it started for the day, it's pretty easy to start after that and doesn't bog. Please don't say check my floats. I've adjusted between 20-21.5mm...

I still can't figure out why it bogs down? Float and needle is right, carb cleaned, no leaks?

OK so I got it not to leak when I turn on the fuel. It will only drip for a sec or two if I shake the hell outta the bike. So I think the float is right. Now I still have a slight hesitation at half to wot. It will hesitate for a sec or 3? then take off and run fine? It kinda bogs for a sec in...

Cool thank you for the reply. I'll double check the valve needle, maybe it's getting hung up? So it's either of the two. I'll check it out and let you know my findings.

OK so I bought the moose carburetor rebuild kit. Everything is the same as stock, by what the imprints says on the jets, needle, and pilot. The stock was 220 and this came with a 230 only difference. Anyways airbox lid is off. New air filter. Tors delete. Compression - 120psi Leak down test...

Yea it's leaking at the cap. I already did a leak down test. When I rebuilt the carb, it came with a flat o ring. Does that go under the cap? or under the other piece under the cap? Also it was only reving up cause the leak at the cap. It don't erratically rev up now. It idles at about 1600 or...

Hey everyone, new here to blasterforums! I have a problem. I tried searching for it but couldn't come up with anything. The problem I have after I rebuilt the carburetor. I put the carb on the bike and routed the throttle cable the same way as it was. Now it revs up (my guess sounds like...