Recent content by crazyjust

Thanks

Does anyone know what size the threaded rods are?

I got the rod out. It is welded. I'm aware you don't have to take the adjustment nut off to pull the pressure plate, but I took the bolts with springs out, and it wouldn't come out. Here is what I did. I took the basket off to change the crank seal. I put the nut on the clutch shaft flush, found...

I am in the process of replacing crank seals on my cousins blaster. When I got to the cluch side, I took off the pressure plate. The rod will turn, but not come out. I'm assume the rod/ball is welded. How have others removed these without splitting the cases?

Ok thanks.

I know this has been asked several times, and I have searched, but I only want to do this once. I have changed the bearings, plastic bushings, and seals in the swing arm. They are in exactly as the old ones were. I have the dust caps with shims, washers, and seals there also. My main concern is...

http://www.blasterforum.com/do-yourself-20/stock-blasty-carb-line-routing-22823/ second pic you will see it blocked with cap

Do you know anyone that has one of these machines that you can use thier puller? Suzuki - Quad Racers, 125/160EK/250R, DR 100/125/00, DS 80, ALT 185, 50 - 125cc Trail & Street Models & Late Model RMs Yamaha - single cylinder quads with external flywheels - YFM80/100/200/225 -...

I would say pull the flywheel and look at the key on the crank to make sure thats ok, and look at the flywheel very close where it slides on the crank. I had a similar issue where my flywheel was cracked (due to overtightening with an impact) throwing the timing off. Would start after about 20...

This will help you http://www.blasterforum.com/carburetor-138/float-heights-how-adjust-them-50565/

The Ratio rite Measuring Cup just might be a good investment. They are sold all over the place for under $10. I wouldn't be without mine.

Congrats guys, and ty for the opportunity to participate.

Ok thanks guys. I will run it for now.

I swapped out my clutch, greased the rods and ball bearing, adjusted like it should be while holding aligned with mark on the case. Then I put on a new motion pro clutch cable that I picked up. The cable was loose and I had to turn the adjuster on the perch just about half out to take up the...

"I want to win"