Recent content by brian3127

  1. B

    Carb jetting

    thanks for the info. Whatsup2day
  2. B

    Carb jetting

    New reeds but nothing fancy. Air box lid is still on. Where is a good place to get jets from. I looked for blaster jets and none that I see match what I have. And its still has the orginal carb. with mods.
  3. B

    jetting the carb size questions.

    I put a Vito's 240 big bore kit and a FMF fatty pipe with a FMF silencer on the blaster. I'm wondering what jet sizes I should start with.
  4. B

    Carb jetting

    I put a Vito's 240 big bore kit and a FMF fatty pipe with a FMF silencer on the blaster. I'm wondering what jet sizes I should start with.
  5. B

    Vito's 240Cc Blaster Big Bore

    I ran the blaster today. Had to put a smaller pilot jet in the carb. Because I could back the air mixture screw all the way out and it still ran. The I had to drop the needle pin one notch. To get it to responded right at 1/4 to 3/4 throttle. Will hopefully do the main jet tomorrow and maybe...
  6. B

    Vito's 240Cc Blaster Big Bore

    Retouqed them this morning All good so far
  7. B

    Vito's 240Cc Blaster Big Bore

    I did the leak down test today. Pressured the engine to 7lbs. And it lost 1/2 a lb in 7 minutes. So I would say that's a successful engine build. Reinstalled the engine back on the blaster and did a heat cycle. Thanks for all the help guys I appreciate it.
  8. B

    Vito's 240Cc Blaster Big Bore

    Ok thanks guy .
  9. B

    Vito's 240Cc Blaster Big Bore

    When I do the leak down test on the engine does it matter if the piston is in the tdc or bdc position.
  10. B

    Vito's 240Cc Blaster Big Bore

    I purchased vito's reed valves VR200 When I took it apart all that came off was the curved metal plate and the reed. Times 2 This kit has what looks like to reeds and a flat metal bar. Times 2 Do I put the flat metal bar on instead of the curved on that was on it to begin with. Or do I put...
  11. B

    Vito's 240Cc Blaster Big Bore

    What is the difference between the stock needle compared to the one that was sent with the kit. Other than the new one is blue.
  12. B

    Vito's 240Cc Blaster Big Bore

    The largest main jet is 340 that came with the big bore. Should I start with that or smaller jet size
  13. B

    Vito's 240Cc Blaster Big Bore

    Ok thanks
  14. B

    Vito's 240Cc Blaster Big Bore

    I bought a fmf fatty pipe
  15. B

    Vito's 240Cc Blaster Big Bore

    The needle bearing on the cranks is good. When I bought the 240 kit it came with jets and a needle for the carb