Recent content by blasDa
-
Fmf fatty pipe flange gasket...
The gasket goes in the cylinder. Doesn’t matter what pipe you have.- blasDa
- Post #9
- Forum: General Support
-
Another idle thread + bonus
In my manual, but not my carb. I was confused also.- blasDa
- Post #7
- Forum: Carburetor
-
Another idle thread + bonus
- blasDa
- Post #6
- Forum: Carburetor
-
2000 blaster dies when throttle hammered
So he's running it lean & destroying the new top end.- blasDa
- Post #14
- Forum: General Support
-
Performance Advice
While you're getting that cylinder ported, might as well get that head rechambered as well.- blasDa
- Post #3
- Forum: Engine Mods and Swaps
-
TRX450 Rear Shock?
Rather than drill out 1 hole & use a better shock? I thought you were lazy?!- blasDa
- Post #12
- Forum: Suspension
-
-
After some small works, mixture got extremely lean
Awk beat me to it. Lol.- blasDa
- Post #5
- Forum: Carburetor
-
After some small works, mixture got extremely lean
I'm gonna go with air leak. Grab a leak down tester (Awk08 sells them).- blasDa
- Post #4
- Forum: Carburetor
-
blaster high compression head how much is to much
Why? He's not trying to sell it. You don't want a head that's just milled off. Get a stock head, and have it properly re-chambered. -
Leak down tester question
What you have is a compression tester. A leak down tester is different. PM Awk08 about one.- blasDa
- Post #2
- Forum: General Support
-
-
YZF600 engine stuffed into a 90 blaster
That things a beast!!- blasDa
- Post #223
- Forum: Engine Mods and Swaps
-
-
Why Crankshaft torched and sheared
Does that not look like a main bearing failure to anyone? Just curious.