Recent content by 99blaster:)

  1. 99blaster:)

    axle nut help!

    thanks alot haha ive been working on putting a 97 rm250 motor in my blaster andbuilding it from the frame up. ive got everything mounted and painted now i just need to paint my carrier and swingarm and put in the fresh bearings. if i cant get it with a cheater ill try an air hammer if that...
  2. 99blaster:)

    axle nut help!

    ive been needing new bearings for a while, but when i went to go put them in the axle nuts held me up. i got the first one off with alot of heat and a pipe wrench with a cheater bar, but the inner nut wont budge. ive been spraying it with pb for 2 days and plan on using alot of heat again, but...
  3. 99blaster:)

    Need Jetting Help

    thanks for the help and before the motor was only .020 over it had everything else on it but its got a high compression piston now and its tough to get good gas around here thanks for the help :)
  4. 99blaster:)

    Need Jetting Help

    im finishing the rebuild of my blaster and need some jetting sizes. it has an fmf fatty pipe with shorty silencer, uni foam filter with holes in the airbox lid, mild trail port and polish, bored .040 over with a wiseco prolite piston, boysen pro stock reeds, +4 mil stroker crank, running on 93...
  5. 99blaster:)

    Shock length???

    ok thanks i appreciate itI:I
  6. 99blaster:)

    just txt me 3158044618

    just txt me 3158044618
  7. 99blaster:)

    hey send me a pm or somthing im interseted in ur powerpros pipe

    hey send me a pm or somthing im interseted in ur powerpros pipe
  8. 99blaster:)

    Pipe Wanted

    do you have the silencer to or just the pipe and how much would you want
  9. 99blaster:)

    Shock length???

    how long is a stock Blaster Front shock in millimeters?
  10. 99blaster:)

    Pipe Wanted

    if anybody has an aftermarket exhaust they would want to sell me send me a pm looking for one for a friendI:I
  11. 99blaster:)

    trouble

    no i didnt do the jetting but i fixed the problem turns out the teather switch was shorting out on the frame due to a bare wire
  12. 99blaster:)

    trouble

    oh and its bored 20 over w a hotrods crank and reeds and stuff
  13. 99blaster:)

    trouble

    i havent done a plug chop but it is piped and jetted etc... the carb was recently cleaned and ill do a comp and leakdown test later tonite.
  14. 99blaster:)

    trouble

    ok so i was out riding last week when my blaster just cut out and died. i changed the plug and it fired rite back up and ran fine for another 5 minutes or so. it was running fine with plenty of power... so i assumed it was just a fouled plug. it did the same thing again and continues to do so...
  15. 99blaster:)

    Cr250??

    i agree the pipe would be the hardest part and you might have to make a custom setup for the airbox idk tho i havent done an engine swap , yet.............