Recent content by 5150

  1. 5

    Tons of Blaster parts for sale

    Yep. I had skidoo 670 cylinders done(2-stroke). I’m pretty sure those guys that do that for a living know what they are doing . js.
  2. 5

    Tons of Blaster parts for sale

    300 seems pretty high. I’ve had cylinders bored (they actually honed .040” over) by a Napa store that had a machine shop for $40. I’d suggest finding a local auto parts that do it.
  3. 5

    Cheap ebay brake calipers and res

    Ive been contemplating going the hydro way for a minute but thought it would be too hard. your pic makes it look not too bad. Could you post a pic and maybe explain what you did for the caliper and mount for that end of the set up.
  4. 5

    Rear Brakes Locking Up

    The little rubber boot that helps hold the outter pad in place is #9 Plug 2XJ-25916-00-00. about 2 bucks on amazon.
  5. 5

    Part #16 for 88-02 stock rear brake

    I picked up a project quad that I'm putting together for my son. I am also looking for a #16 plate guide 2XJ-25689-00-00. The rest of the parts I need for inside the caliper are easy to find and cheep. I have seen these going for pretty big bucks also. it rally looks like it should be about...
  6. 5

    Tons of Blaster parts for sale

    Do you have the factory rear caliper. I really just need the mechanical adjuster mechanism . (88-02). Shorty cable too?
  7. 5

    Tons of Blaster parts for sale

    I don’t know how either. Lol
  8. 5

    Which throttle cable

    Mine is a 1999. I believe that’s the thread I read. Please correct me if my thinking is off. What I did is unplug the system by unplugging 3 places: wire coming from thumb throttle (black connection), the “brain” (white connection), and the white connection coming out of the “brick”. I just...
  9. 5

    Which throttle cable

    I’m mixing because the oil tank is missing. I did just have the oil line in the brass nipple when trying to get it to run. I’ll get a vacuum cap. After installing the the rebuild kit, and adjusting the float height it will fire up and idle high(throttle valve is too high) it will die when I try...
  10. 5

    Which throttle cable

    Throttle body and needle are good,cable routing is ok, the screw on the brick don’t seem to change idle much. I’ll pull the carb out and see if I can adjust cable slack/tightness.
  11. 5

    Which throttle cable

  12. 5

    Which throttle cable

  13. 5

    Which throttle cable

    Thanks for the reply. When my rebuild kit comes in, I’ll try to upload a pic.
  14. 5

    Which throttle cable

    Sorry to hyjack this thread but I can’t figure out how to start my own . Does anyone know what the gap is supposed to be on the throttle valve. I just finished the diy tors removal ( basically just in plugged it)on a blaster I just picked up. It won’t run hardly at all. I found the needle and...
  15. 5

    Tons of Blaster parts for sale

    Any chance you have an oil tank and associated brackets. I’d like to reconnect the oil injection system on a blaster I just bought.