Need help with rear hydro setup

Your blaster is not an 06.. It is an 88-02.. I can tell just by the pics posted. Whats the 10th digit of your vin#?

It’s an 06. 10th digit of the vin is 6. I cut the original brackets off and welded new tabs to fit the new Banshee rear master. The PO had swapped the carrier for an unknown reason.

12BF488B-F797-4B9F-BFB6-28F69422AEE4.jpeg
 
Last edited:
My title states 2006 and the complete VIN is:

JY4AG02356C041110

So yes, It’s definitely an 2006 YFS200 SE

Also, Still has the original Black/Purple flame plastics.
 
Last edited:
Gotcha..Fair enough.. I seen the master cyl mounts and wondered why they were cut off. A banshee master is different than an 03-06 bolt spacing wise. That's why it wouldn't work.
 
Hey guys so I have an 02 blaster with a hydro rear brake and Ive had nothing but problems with it since I got the quad first it would only lock up if I pressed hard so I bled the line completely threw and now I have no rear brake
 
Did you do it properly maybe not building enough pressure, replace all copper washers, look for wear on cable and use dot 4
 
Did you do it properly maybe not building enough pressure, replace all copper washers, look for wear on cable and use dot 4
I didn't replace the washers I'll do that today and I used dot 4 and I feel like I bled it more than it needed to be just to be safe I had only fluid flowing out but it wasn't spraying out
 
if the tabs were missing for the master ? then they were either cut off, or that's not an 03-06 hydro brake frame ?
what makes you think it's an 06 if the brakes and frame don't match 03-06 ?
Awk08 I need one of your rear hydraulic kits for my 94 blaster just joined site my email is sowerschad@yahoo.com