Won’t run with air box lol d
- Thread starter josh519
- Start date
Idle speed adjusting.
Set float level, make sure that all jets are clean and fuel flows freely from the float bowl drain
when the screw is cracked open.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of
unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor responds.
Re adjust idle screw for desired idle .
if the air screw ends up being more than 2 1/2 turns out the pi;]lot is too big.
if the air screw is less than 1/2 a turn out the pilot is too small
Set float level, make sure that all jets are clean and fuel flows freely from the float bowl drain
when the screw is cracked open.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of
unit. With no TORS is is the brass screw midway down carb body.
Warm up motor and then set idle screw for a faster idle, 2000rpm+
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs or until the motor responds.
Re adjust idle screw for desired idle .
if the air screw ends up being more than 2 1/2 turns out the pi;]lot is too big.
if the air screw is less than 1/2 a turn out the pilot is too small
