So i took 2 bikes and made 1 so now I have a 200 stroker with a machined head procircut exhaust and the stock mikuni carb any idea on were to start jetting its stock jetting and the needles in the third clip lol not try a blow this one up oh and vforce3reeds with spacer
Well i took two and made 1
- Thread starter Alwayswrenchin
- Start date
Firstly leak test the engine before you start to do the heat cycles.
Jetting info needs to know , the type of air filter, oil ratio and if the air box lid is on or off, the temperature and elevation.
The needle in the middle clip position is the norm.
Jetting info needs to know , the type of air filter, oil ratio and if the air box lid is on or off, the temperature and elevation.
The needle in the middle clip position is the norm.
Elevation is approximately 1500 ft foam filter air box is intact d the weather's been in the 50's
Similar threads
