TORS Eliminator it..do I still need idle??

[Chuckthizzle]

Ok this is the kit I have...Do I still need to purchase an idle screw like the VItos one? Or am I good??

Motion Pro Tors Eliminator Throttle Conversion Kit for Yam Banshee 350 1987 2006 | eBay

 

[davenichole]

you will definitely need the idle screw kit. it is a pretty simple install. i have done a couple. the place where the idle screw goes, make sure you machine or file that edge flat instead of it's current angle so that the jam nut has a flat surface to tighten against. i was able to use a small spring in place of the jam nut on one carb.

 

[davenichole]

also, in that listing, it tells you this... "NOTE: Kits eliminate stock carb tops with idle adjustment and automatic kill switch. For normal idle, use Motion Pro kit 08-0045". what you have is Part Number: 01-0351.

 

[mud runner]

you might be able to ajust the idle on the handle bars

 

[davenichole]

you might be able to ajust the idle on the handle bars

one might, but i certainly wouldn't recommend it.

 

[Blaaster]

One can adjust the idle by adjusting the cable but when you turn the handlebars the revs will increase due to cable tightening.

 

[Chuckthizzle]

Dang...Before I buy this part and shell out some extra bucks let me ask you all a question is it worth using the Eliminator kit??? Any real difference?

 

[Blaaster]

Reliability is the key issue, the TORS has a dismal record of failure, and leaving you to walk home.

 

[Herpderplol]

Its also 100x easier to take the carb out of the blaster if you have to for some reason, i always took off the gas tank when it have the block...

 

[Chuckthizzle]

Ok, I will order it then good stuff thanks guys. As far as grounding that one are flat, I have a dremel so maybe the sanding disk or grinder

 

[Herpderplol]

Use a file, its the only safe thing to put that close to your carb i would say...

I used a small round diamond bit on my carb, but hopefully you wont have the problam i had

 

[Chuckthizzle]

I would think a handfile would take forever...

 

[Wifesblaster]

I would think a handfile would take forever...

It's soft aluminum. If it takes you more than 2 minutes you need to hit the gym

 

[Blaaster]

I would think a handfile would take forever...

We breed em tuff in Aussie, five or six strokes of a Bastard filled with chalk is all it takes!