Swapped blaster motor yz250

Poisonthewell

New Member
May 15, 2015
6
0
22
41
I need help with the wire set up with the engine swap can I use the blaster wire harness are do I need to use the wire harness from the yz250?
 
Use the YZ ignition wiring. Does this motor even have a lighting coil? If it does I would think it is fine for the Blaster regulator.
 
The motor is off a 1993 yz250 the bike had light on it that I took it off of but does anyone have a wire diagram for a yz250 because I can't find any one the web
 
Use the YZ cdi & coil .. you can use the black & black/white wires with the Blaster run/off system ..if there is a charging coil for lights it should be a yellow wire not shown in this diagram .. the lighting coil comes in the WR250 .. if you have the yellow wire it will run the Blaster light system.
---

93%20yz250%20wiring.jpg

 
Last edited:
Last edited: