I have a 97 blaster. It starts up and drives great. After a few minutes the quad spudders out and dies. 10 kicks later it starts up and runs good for a few minutes then dies. The gas line runs when not on carb but goes empty after driving, it still runs after restart with only half the line full. So the carb isn't taking enough gas, even though the float is set to the manuals hight and new not sticking needle and seat, gas tank filters are also clean. After I get back in the yard the spark plug is running a nice tan brown, so it's not lean. I don't know what is wrong, this is a list of stuff that I've done and covered that are not the problem:
-new carb boot
-clean carb and rebuild kit
-float hight is right
-gas tank is clean and flows when not attached to carb
-125psi compression
-has good spark and coil isn't bad
-removed/unpluged all tors system
-new carb boot
-clean carb and rebuild kit
-float hight is right
-gas tank is clean and flows when not attached to carb
-125psi compression
-has good spark and coil isn't bad
-removed/unpluged all tors system