rebuild complete

[04blasted]

Just got the new top end broken in, I think it's time to RIDE!!

 

[Larry's Shee]

Do a leakdown test yet?
Do ANY mods that will require jetting change?

 

[04blasted]

Do a leakdown test yet?
Do ANY mods that will require jetting change?

Have not done leak down test yet. I plan on one soon. no mods to jetting, the only thing I did was bore out cylinder from 66mm to 68mm.

 

[Fast6hand]

I hope you bored so much because you had to.

 

[04blasted]

I hope you bored so much because you had to.

I bored out 2 mm more so not to much but had some expensive porting done to it, witch made it pretty damn fast.

 

[Fast6hand]

It is a lot considering 66mm is stock bore, and now your on its last bore. If the cylinder wall is good you can get away with just boring to the next size or two. Boring the cylinder larger doesn't really increase power, just cleans it up to except new piston/rings. You could typically get 6-8 overbores.

 

[04blasted]

It is a lot considering 66mm is stock bore, and now your on its last bore. If the cylinder wall is good you can get away with just boring to the next size or two. Boring the cylinder larger doesn't really increase power, just cleans it up to except new piston/rings. You could typically get 6-8 overbores.

I bought the blaster for 400 bucks, it needed top end because it was pretty scared, blown completely haha I just did it to 68mm. it runs great I might sell. Hahaha I only have 600 into it so I could make pretty good profit

 

[Larry's Shee]

Just a suggestion. Clean the pipe and silencer up and give it a shot of BBQ paint. Will look 10X better and make it easier to sell.

 

[Fast6hand]

Making some money is always a good thing.

 

[04blasted]

Just a suggestion. Clean the pipe and silencer up and give it a shot of BBQ paint. Will look 10X better and make it easier to sell.

Great idea