Really need help

[Brenden Duso]

so I installed the Vitos idle screw kit and it will now idle but not right , it will idle high then idle so low that it stalls I don’t understand why , After going for a quick lap around the yard or something it will idle really high then after about 30 seconds it will drop to a normal idle . What’s with the high idle ?? What should I check ?

 

[blaster0187]

hav u checked ur throttle cable? i like to take off tail and look inside carb at carb slide turning idle screw in until it just starts moving slide...then start it up and set the idle.......MAKE SURE THROTTLE CABLE HAS SLACK....if the cable is too tight at the thumb throttle it will idle up and down when u turn bars...

 

[Brenden Duso]

hav u checked ur throttle cable? i like to take off tail and look inside carb at carb slide turning idle screw in until it just starts moving slide...then start it up and set the idle.......MAKE SURE THROTTLE CABLE HAS SLACK....if the cable is too tight at the thumb throttle it will idle up and down when u turn bars...

Might be too tight , will adjust to make some slack and try

 

[Larry's Shee]

Just enough thht you can push throttle a bit before it takes up the slack..