Loss of spark?

[Jtrainor57]

I have a 2000 blaster that i bought off of somebody cheep because they couldnt get it to run. The wire leading to Ignition coil was unplugged. Low spark after that. got it to start by push starting with another quad, road it for the day. Now the next day it wont start at all and no spark

 

[Larry's Shee]

Start by cleaning all connections in wire harness. Bypass switches. Ohm stator coil, ignition coil, and plug cap seperatly. trim 1/4 " off coil wire before installing plug boot. Use dielectric grease on connections.

Don't know if switches are normally open or closed , for test porposes., it does matter. Maybe someone will chime in to help ya.

 

[Jtrainor57]

Thanks i just ordered a new stator today. Checked and found out i was not even getting anything to the coil, so it was fine, then i tested the CDI with one off another blaster that i know works. No solution, all switches are good to

 

[Jtrainor57]

I got the new stator on and it fired right up. Running 3 to 5 degrees advance timing. It makes a huge difference