Gas/Oil mix, what's the ratio?

Discussion in 'General Support' started by jasonboarder298, Nov 11, 2010.

  1. jasonboarder298

    jasonboarder298 New Member

    Joined:
    Nov 11, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Ely, MN
    Stock I know I should mix 32:1, but my Blaster is bored .5 over, any suggestions? It's a 2001, and the oil injection is blocked off
  2. sheeblast

    sheeblast New Member

    Joined:
    Jul 16, 2010
    Messages:
    4,656
    Likes Received:
    45
    Trophy Points:
    0
    Location:
    Ohio
    ya, i think you mean .050" but 32:1 is still good.
  3. acezeesawtooth

    acezeesawtooth Member

    Joined:
    Aug 8, 2010
    Messages:
    1,928
    Likes Received:
    31
    Trophy Points:
    53
    Location:
    Indiana, PA
    32:1 .050 is negligible
  4. blasterdemon7

    blasterdemon7 I'm not mad. I'm winning.

    Joined:
    Nov 19, 2009
    Messages:
    13,381
    Likes Received:
    172
    Trophy Points:
    68
    Gender:
    Male
    Occupation:
    Automotive dismantler
    Location:
    Delaware
  5. brandoz28

    brandoz28 Member

    Joined:
    Sep 24, 2009
    Messages:
    10,761
    Likes Received:
    93
    Trophy Points:
    53
    Location:
    Iowa
    running 32:1 in my crate, and its 1.25mm over


    and it could be .50mm over sheeblast
  6. sheeblast

    sheeblast New Member

    Joined:
    Jul 16, 2010
    Messages:
    4,656
    Likes Received:
    45
    Trophy Points:
    0
    Location:
    Ohio
    true, but i was thinking in inches, reason i said .050"
    either way, it doesn't make a difference in the engine.
    32:1 is your best bet for good projection and lube of the bottom end.
  7. oldskool83

    oldskool83 New Member

    Joined:
    Apr 15, 2010
    Messages:
    159
    Likes Received:
    1
    Trophy Points:
    0
    Occupation:
    hand job
    Location:
    up ur ass
    32:1, being bored has nothing to do with it. and .50 over aint much anyway.

Share This Page