Drag engine

Unscarred

New Member
Dec 25, 2010
2
0
17
42
Wappingers Falls, NY
Hi i recently came across a good deal on a drag blaster. The guy i bought the quad from did not know much about it other then the motor having alot of work done. My question is, would i be able to put this drag engine in a mx blaster im building with a fmf pipe and re jet the carb or would it harm the engine if it is ported for the drag pipe?
 
Last edited:
Not going to harm the engine if it's jetted correctly for the pipe and carb you use. Without knowing what all is done to the motor it is tough to say what performance will be like. If it has an oof pipe on it now and you switch to fmf chances are it will be a lot slower if it was ported for the oof pipe. If it was properly setup as a purpose built drag engine then you could have heat issues. Chances are it just has some mild porting and is not a full drag engine and you should be fine. Post up some pics of engine/quad closeups. Not that we can tell you whats done to it from the outside but it will give us an idea of cylinder used, etc