Search results

Problem solved it was the reeds i pulled them out this evening and they were hosed i put the old stockers back in and ill test tommrow but by the look of the old reeds there is no doubt they were bad

I do have an excuse to not have a job I live in the middle of nowhere so i cant walk to a job and both parents work late leaving me with no way to get anywhere. I wasn't complaining about not having a job i'm just saying there is no reason to do a rebuild if its not needed especially if you...

whats your point

I had idleing backfiring issues. check your wiring harness for any wires touching any metal that are bare. it wouln't hurt to cover whole harness in electrical tape. also check your reeds for any chips cracks or damage

Easier said than done when your 15 and don't have any income yet but the reeds will be done asap and i think that will fix the problem, but if not the top end will come over winter.

probably wasn't too late ran good for a while after that.

I have the tors removed and a 280 jet which was running good for a good bit of time with a golden brown plug. I had stock reeds in it and replaced them with boysens it ran good for a while then started to get like it is now then wouldn't fire at all and had no compression. the boysens broke so...

blaster isn't at my house right now so ill have to try this stuff this weekend and ill let you know.

Ok guys my blaster is getting difficult to start 1st time. It will start after about 3 kicks with choke when it used to start with just 1 kick no choke. after it gets started it runs fine but seems to have no power. it flies through 1st 2nd and 3rd then bogs out in 4th also it won't do a...

bump 1515151515151515115

Put castrol super clean in a spray bottle, spray the head, then scrub it with a strong scrub brush, then spray it off. repeat until its clean enough

I got it to start today but it only ran for about 5 seconds then shut off. I had to use the choke to start in on a 95 degree day and never had to use it before. When i tried to start it back up no luck. One of the reeds isn't completely sealing because it has a tiny chip on the corner could...

I have changed spark plug didn't help. I will check the woodruff key in the morning but what does it look like and how do i know if its good or bad. (Don't know much about the electrical part of blasters.) Rep Given

My Blaster won't start and i dont know why. It was running fine for a while then it got to the point that it ran but with backfiring until it was warmed up. Then I thought I had an air leak and found that I did around the reed gaskets so i put rtv on them. After that it ran fine for a while...

I need a silencer with a spark arrestor for cheap. A stock one would be fine. Let me know what you have for what price shipped to 15601

I was on a camping trip this past weekend and we went past mountain ridge. It looked like it would be a good time. Trying to find a time to go. It is about an hour from my house.

Got it welded by my uncle just enough to hold it then put epoxy around it to seal it so it holds oil. Working great!

JB weld does work great. It held for an hour and broke. It works fine except in my condition. it isnt just a crack, there is a whole chunk of the case gone around the shift shaft. i think it would hold a chunk even but you are always pushing on the shifter so tere is too much stress for jb...

everyone who says about these stock stickers on ebay send me some links cuz i can't find them. Also any other recommendations about the plastics will help