Search results

  1. liljatownboy

    FS: 94 Camaro Z28 6 speed. N.C.

    bad idea!!!!!!!!!!!!
  2. liljatownboy

    my blaster wnt start. help! i love my blaster

    yes have have about 2-5mm (not exact numbers) of play on the rod side to side they should have the limit clearance of play in the Manuel
  3. liljatownboy

    How can i connect Koso rx1n rpm counter?

    it is suppose to go around you plug wire and then grounded
  4. liljatownboy

    front shock

    picked some up from stabor1122 thanks
  5. liljatownboy

    Boggy off idle and can't pull high gears

    have you messed with your flywheel may have a key that sheared and move flywheel slightly. happened to me the weekend no power at the high gears.
  6. liljatownboy

    Carb trouble i believe

    if its in gear will it rev high with the clutch in
  7. liljatownboy

    Carb trouble i believe

    air leak did you use new gaskets?
  8. liljatownboy

    front shock

    what color springs?
  9. liljatownboy

    front shock

    so i was on the trails the today and went over a fast whoop section the top spring stop came off, so on the next whoop section i bent the shock and it leaked everywhere. so just looking for a pair of the same color of front stock shocks.
  10. liljatownboy

    my blaster wnt start. help! i love my blaster

    probably seized it due to air leak what ratio of oil were u mixing
  11. liljatownboy

    Ninja 600 bobber/rat bike Trade

    if he was closer id trade him my blaster
  12. liljatownboy

    need help choosing a 240 kit

    Yes probably but I bet if you pick that cylinder up you can make a pretty penny on it here or ebay
  13. liljatownboy

    chance to upgrade

    try to trade him yours with cash on top
  14. liljatownboy

    lots of parts...thanks to oregondunes!!

    got a good coil?
  15. liljatownboy

    I Bought A Vitos BB Kit Now What!!?

    yes you might need that but not sure if it fits stock cylinder
  16. liljatownboy

    I Bought A Vitos BB Kit Now What!!?

    if you are using a stock cylinder it is gonna be hard to make this work because the vitos is a 12 port sleeve. so you might want to look for a bb cylinder that needs a new sleeve
  17. liljatownboy

    hard starting

    Yea it will run good if they are there but it will cause hard starting if they are broke
  18. liljatownboy

    DIY Big carb in A lil' boot.lol DONT cut one up!!! try this!!!

    what size carb you use?
  19. liljatownboy

    hard starting

    im going to say its your reeds that are bad if not compression
  20. liljatownboy

    timing advance?

    i changed mine 4 degrees and it f*cked my engine it would pop and backfire at full throttle. it may be cuz i have a keyway that it is about a 1/2mm skinnier and it was advanceing to much but i didnt try it halfway just went back to stock
Top Bottom
Back