Search results

i figured it out for now it isn't what i wanted to do but i had to put my stock steel front wheels back on. they clear perfectly fine. my problem was that the yamaha aluminum wheels were 10x6 and the stock blaster wheels are 10x5.5

1) What type of aftermarket exhaust do you have? power pros/factory7 2) What type of airfilter do you have? uni two stage 3) Are you a)running a stock airbox with lid stock airbox with NO lid c) Stock airbox with vents d) no airbox at all stock air box for now no lid 4) What is your elevation...

i recommend pre mixing your oil instead of paying 40 bucks for the little aluminum block off plate take the pump off of your side cover throw the little plastic gear in the trash. then take the 4 screws out of the front of the pump and take the 1 gear out of it but leave the shaft that sticks...

i have the power pros right bend pipe on my blaster which is the same thing as the f7 pipe without the f7 sticker. it works great has good power all over from bottom to top but i also have a +3 stroker and my cyl has been ported by Flotek. but if you have the toomey pipe already i would spend...

im pretty sure they are the 3 on 2 im not 100% sure what they came off of i know they have yamaha stamped on them

i just got the asr Lt +3 a arms and the factory yamaha aluminum front wheels will not clear the upper heim joint. i was wandering if someone ran into this. if i flip the wheels inside out they clear by a mile but my fourwheeler is almost too wide for some of my trails.