Search results

  1. 2

    Where to buy a quality carb rebuild kit and float

    My 2003 Yamaha blaster leaks gas out of the carb through the long overflow tube when gas is on or it's at idle. I think the float might be sticking or the seat might not be sealing well. Where could I find a quality rebuild kit and float, not some cheap Chinese kits that make my bike run like...
  2. 2

    Oil Mix question

    I just removed my oil tank and plugged up the hole in the carburetor and the two holes on the oil pump with vacuum cap hoses until I open my blaster up again to remove the gear and pump. I have just bought Amsoil dominator oil and some people say to 32:1 with it is too much and will cause bad...
  3. 2

    Stuck Pushrod

    The Clutch mechanism on my 2003 blaster went bad, I bought both pushrods, ball, pressure plate, and nut and washers. The problem is I can not get the second longer pushrod out. I tried tapping it with a hammer while the bike was leaned sideways so it would fall out but didn't. I tried removing...
  4. 2

    Clutch Adjustment Question

    I just installed my new EBC clutch and rotated the steel plates every 2 groves, does that seem correct? When I pull the clutch lever, it moves 7-10 mm before you start to feel the tension of the clutch engaging. The clutch pressure plate moves 2-3 mm out, is that the distance it should move...
  5. 2

    Idle and fuel question

    Some people say you can't let a 2 stroke idle and you have to keep blipping the throttle, because you will foul a plug or blow your top end due to not enough oil at idle for the piston while others say they let their blaster idle all day and never had a problem. I would like to know if I could...
  6. 2

    Transmission Oil

    I want to change the transmission oil in my 2003 Yamaha blaster but I am confused about which oil I should put in it, the manual states SAE 10w30 should be used but other people on this forum say not to use SAE 10w30 and to use ATF, ATF type F, or ideally Motul Transoil 10w30.
  7. 2

    Clutch Issue

    I just bought my first atv, a 2003 blaster, and the previous owner told me the clutch needs to be replaced because it slips and I shouldn't ride it till I fix the clutch. How can I verify that I need to replace the clutch due to it slipping? If I need to replace the clutch, what brand would be...