Search results

Thanks bud

And why are there 2 bolts on the right back side one was loose couldn't screw all the way on

this is where I'm hearing squealing from on my raptor 660 it's not brakes just checked those is there anything else I need to check

Any knowledgeable mechanics in here that knows a lil about the raptor660

Hey awk do you know anything about the raptor 660

Ok thanks for info i just been riding around like crazy on it..runs great just that ticking sound glad I know now gonna park her for a while n fix..guess I'll ride my 300 till I fix blaster

Yea I kinda figured that lol I heard that a few times with old blasters I had..until I did research n seen they just say that to get a sale lol

here's a video on how it sounds

Not to good with the names of stuff still learning but I have the big pipe and a small muffler guy said it was bored to 300 but I know thats a lie lol haven't went and checked piston size carb jet size said 240 on top and I have my needle on 3rd notch and I'm using the oil mixture on side seems...

Thanks alot man I appreciate all you guys help best forum I've been in much appreciated

Got it to idle with kit installed without brick think I need to file just a tad bit more to make sure its flat all the way now gotta figure out when I open it up fill throttle it kinda bogs down until I slow down a little then I can keep riding do I need to turn throttle screw on top of carb a...

Here is a pic on how much I have screw in at #1 do I need to have in to like #2 or #3..didn't wanta screw in to much didn't wanta damage carb

I'll try and shave down a little more..wheb I look through hole i can see it through carb it sticks out ..how far do I have to shave in

@Awk08

Tors kit and brick ..had to put brick back on after I put kit on seemed like cable was to long won't stay idled but since I put brick back on it stays idled but can't adjust the idle any suggestions

Long story short I put on tors eliminator kit. Couldn’t get to idle had to hold throttle to keep idled..so I just put my tors back on just to see will it stay idled .it did just couldn’t adjust idle any ideas on what it might be now I have 2 idle screws tried to adjust both but no luck on idle...

Awk08 I put my tors back on and now it holds a steady idle and won’t shut off but still can’t change idle

Hey awk I followed steps on the new eliminator kit but it’s seems like new cable to long or I’m not adjusting throttle cable right seems like it’s to much slack..it won’t idle have to hold throttle to keep idled and then gas starts pouring out carb bottom have to turn gas off cleaned carb a...