Search results

I have the old Vforce 2 reeds in my 99 Blaster which need replacing. Through searching this forum I have found the replacements and they are available on Amazon , but the gasket seems to be obsolete. I know that the bolt holes will obviously be the same for all but does anyone know if the 3 or...

Change the gear oil , put a zip tie around the clutch lever holding it in , start it in neutral , get it rolling , the jump on , hit 1st gear and ride it around for while. Stuck plates will usually free up with heat and fresh "safe for wet clutches" oil.

Thanks for all the tips , put 45 miles on it yesterday. Goes awesome.

Thanks for the reply , the basket is good and I have a Tusk kit on the way.

more recent pic.

i have been riding my $500 blaster all summer and it has been great , but it is in need of a new clutch. I have been reading over the clutch threads and have a few questions. I have the clutch cover off and have removed the plates, rod , and springs also I have done clutches before. That being...

I'll check on the brand , it was made in the US from eBay for $45 or so.

I am putting my bumpers on today , I bought an aftermarket rear and a stock front on ebay.

My wife's Suzuki Ozark.

Thanks guys , glad this is a lively forum.

I know , that is how bad the axle carrier and bearing were gone. Fixed now

Hello all , I just picked up a project 99 Blaster for $500 and after replacing the rear axle housing and bearings she is up and running. Look forward to being a part of this forum as I build this quad up. Dan