Search results

Ya I haven't found much a company is making a hooker replica but its listed for the 250. I'm going to see if it would work they look about the same. The aftermarket for the xr is huge. Trying to find out if a slip on for a xr will fit xl. May have to go custom rout

My old man just scooped up a 78 xl350 and was looking to put a different exhaust. I haven't been able to find much aftermarket parts for it. Figure some one mite be able point me in rite direction. I see videos of them with aftermarket exhaust but can't find a system. Any help is appreciated!

Good I didn't take it out and give it a solid run down due to 20 inches of snow. I tryed it in my garage seemed to work well!

my idle screw is all the way in as far as it will go just to get it to idle at all if I back off on idle screw it falls on its face. maybe some of the boss needs to be filed off? it seems to be drilled and tapped pretty good. it has been filed flat. thanks for the info guys. looking like I most...

Ports have been smoothed out not really opened up though. It's .06 over boar, has full fmf, and open box top. Tors is long gone and so is oil injection. My jetting may not be spot on but with the way the weather has been lately not much riding has been done. It ran fine with that set up in the...

Highest idle isn't 1/3 out. That's where it idles well. It's got stock pilot and a 340 main. I will havta confirm that though. Iirc I'm one spot down from middle on the needle. I rebuilt carb its all new everything and it made no difference. I should be up at the garage in the morning working...

haven't done a leak down yet but, not oil injected properly blocked off. yes did plug chop tried dif plug, the electrical connections are clean, no air leeks at the carb boot, and I warm it up til the engine is warm to the touch. I will do a ohm test on the coil and do a leak down test. I...

Also changed pet weiner, fuel filter, did carb rebuild kit, put in fresh fuel, and checked reeds. None helped.

Been trying figure this out but no luck so far. Let my blaster warm up a few minutes then take off it runs rough. Not a miss fire or sputter sort of an extra vibration. After goin for about 2 min of riding it would go away smooth out run as normal. It felt like when a plug loads upnd then crack...

All ready changed the iac didn't change anything. My computer doesn't have the scope its kinda old but works really well. I can get my hands on a newer snap on. I may have another 02 sensor to swap and try. I will check the fuel pressure for sure. The filter is about 2 years old maybe just...

Sure did it was running ok when I put it in the garage 4 months ago. I run it here and there too. Fired it up other day and this happened. The hunting deal happened before though lean is new. It's frustrating have lot of time and money into it.

I'm going to toss fuel pressure gauge on it tomaro. I doubt that will tell me much its a return fuel system it runs wfo and sends what's left back. There isn't much on it for vacuum. Checked what was there no problems. I mite make a build thread for it . Cars really fun to drive but its not up...

I have a 95 Saturn sl2 that's modded pretty good. I fired ot up yesterday and it ran about a minute and started idle hunting. Then my afr went off the gauge LEAN! Car warms up to about quarter on temp gauge and idle smooths out. I tryed changing iat and tps. The coolant sensors are new as well...

A lot of people around here having issues toowith those. From what iv heard new carbs on them are just junk can't do much with them

32.5 jet was very clean whole carb was clean as a whistle. Yup its stock carb I haven't messed with main much because in the pilot jet thread on here it says its a waste to mess with main until can get the pilot close. Idle screw drilled and tapped proper. Is there a way to know where to set the...

Yup I did I couldn't get it running. That's why I was confused. I put 30 back in and it started back up no prob. I have a carb rebuild kit to put in it so I will take your advice and rebuildkit see what happens.

I tryd to put stock one in and I couldn't get it to run at all. I will follow what's in link tomaro and see how it goes. I figured some one would say that haha.

My air screw is about 6 turns out. I have a 30 pilot from a Vitos jet kit because it was recommended. I put stock 32.5 and Vitos 30 up to light and the 30 is bigger. Kinda stuck on what I should do here. Also its been running rough. It would run rough then as I road a min or so clear out now it...

my gf has a 99 that runs well. it start fine but after riding for a while it starts racing and has a hard time idle. any things i should look for? carb is nice and clean. not sure what to look for.

Im using valvoline 4t. I ended up switching the transmission over complete from parts motor and all is fine now. Im not sure what is wrong with gears I swapped out. They seem to be fine. I changed the shift drum and shift levers it didn't change anything. So I swapped both gear sets and it works...