Recent Activity

Activity stream for all registered members at Blasterforum.com.

  1. Brenden Duso replied to the thread 02 blaster keeps blowing up.

    Turns out the cylinder was out of whack , the shop I brought the cylinder to actually screwed it up(wasn’t round) . they bored it and...

    Feb 23, 2018 at 4:12 AM
  2. Brenden Duso posted a new thread.

    Headlight removal help

    okay so i have no use for my headlight , it’s an 02 and i know how to completely take the headlight itself off , however what do I do...

    Forum: Miscellaneous

    Feb 23, 2018 at 4:07 AM
  3. Jre720 replied to the thread Picked up another blaster today.

    Finally got outside yesterday been super cold in NY yesterday was 70 degrees and today it snowed go figure lol anyways swapped out coil...

    Feb 22, 2018 at 10:41 PM
  4. TrynaLearn replied to the thread Premix oils.

    I have that now just asking for alternatives in case I have to go local I have also heard Mobil 1 make a pretty good 2 cycle

    Feb 22, 2018 at 10:14 PM
  5. blasterbrian replied to the thread Premix oils.

    Yamalube 2R

    Feb 22, 2018 at 10:11 PM
  6. TrynaLearn replied to the thread Premix oils.

    What about that the Lucas semi syn is anybody using this for premix and if so what's your opinion on it

    Feb 22, 2018 at 10:08 PM
  7. Larry's Shee replied to the thread Gets going works and bogs every so often.

    Do a TORS delete to rule that out. Clean carb may help. Set float level and idle screw.

    Feb 22, 2018 at 9:36 PM
  8. Larry's Shee replied to the thread Premix oils.

    Lots of choices. I love bean oil , but can't run it below 40*. Yamaha 2s is good. Quicksilver is a good oil WHEN USED AS INTENDED. A...

    Feb 22, 2018 at 9:31 PM
  9. Larry's Shee replied to the thread Kick start return spring.

    IIRC there is a little loop on bother ends, look at a parts diagram to verify.

    Feb 22, 2018 at 9:22 PM
  10. Larry's Shee replied to the thread No clue but maybe you do.

    Even though an air filter may not seem like much, it adds one jet size. Read up on plug chop, carb cleaning, float level. Either get a...

    Feb 22, 2018 at 9:13 PM
  11. TrynaLearn posted a new thread.

    Premix oils

    just wondering I just could search and find it even tho I'm sure it's on here.... but is quicksilver 2 cycle good for premix or any...

    Forum: General Support

    Feb 22, 2018 at 8:39 PM
  12. speedyslyder replied to the thread Kick start return spring.

    what about these videos:eek: part 5 is the spring.. Have you bought a new spring or seen these? did it worked before you replaced the...

    Feb 22, 2018 at 8:35 PM
  13. Pj Uptmor replied to the thread Carb/cable help.

    Check on the main jets and pilot jets. mukuni won' fit ur carb. I was burn on this carb.

    Feb 22, 2018 at 6:29 PM
  14. Sam Romero posted a new thread.

    Kick start return spring

    I have a 1998 blaster kinda a basket case. Anyways replaced the clutch and now I cannot make the kick start work. Now before someone...

    Forum: Do It Yourself

    Feb 22, 2018 at 6:25 PM
Loading...