Magnum EZ Pull kit!

79 bronco

Moderator & Self Custom Psycho
Staff member
Apr 9, 2010
5,420
774
178
47
I don"t know???????
Got my Magnum EZ Pull kit, its simple! But probably wont break like the Moose ez3 pull i had! http://www.blasterforum.com/threads/moose-racing-ez3-clutch-lever-assembly.64479/
104_8870.JPG
104_8871.JPG
104_8872.JPG
104_8873.JPG
104_8874.JPG
104_8875.JPG
104_8877.JPG
104_8878.JPG
104_8879.JPG
104_8880.JPG
 
  • Like
Reactions: Lyndle
The Magnum EZ Pull clutch looks very similar to my old stock clutch.
But the pivot on the Magnum EZ Pull is smaller and the spot where the cable goes is in a different spot.
104_8881.JPG
104_8882.JPG
104_8891.JPG
 
hmmmmmmmmm Makes me think that if you have a decent drill press, you could drill out a new hole in the stock lever, then maybe dremel out a channel for the wire.....hmmmmmmmmmm
 
lol
Yes its easier, and it's a 4 finger lever. But the lever is not quite as long as the lever that was on my blaster!


I was trying to use a OLD fishing scale on the lever that was on my blaster to see how many pounds it takes to pull it in. But it did not work very good. Need to get a better fishing scale? lol

104_8888.JPG
 
I had an outlaw racing easy pull clutch, It was machined instead of cast, the only problem i had was the jam nut, the threads were all messed up when i got it but I ran a tap through and it worked perfectly. Best $18 I ever spent! I highly recommend, the clutch was smooth and easy, but a little longer than the original. Its on amazon for the YZ but they're the same lever from the factory.