The bottom of the rod hitting the case...
Before
After
Some filing at the top
Now it fits
Case Trenching pics.......
- Thread starter 79 bronco
- Start date
The bottom of the rod hitting the case...
Before
After
Some filing at the top
Now it fits
Top notch fabrication, as usual there Bronco.
How ya been bro??
Ummmm, any chance on fabbin' up one of them secret skids for muah yet??? (shhhhhhhh)
Later bro, bravo on the trenchin'
How ya been bro??
Ummmm, any chance on fabbin' up one of them secret skids for muah yet??? (shhhhhhhh)
Later bro, bravo on the trenchin'
you know where to find that info, he harbors few secrets
Are you talking about Ken? Just ask Ken he knows how much did you remove!
Off the top of my head....3mm from the inside diameter. Make sure you indicate the case where the bearing goes in, not from the crankcase. You need .5 mm clearance from the case to the rod when you're finished.
Similar threads
