Recent content by twinrock

Thanks will. Do

Hey guys inhave a Vito big bore kit I bought second hand and have been happy with it however it's become quite noisy and the rings have always been very sloppy. Do u know what rings are compatible with this piston.. I'm. In Australia no one deals in blaster aftermarket stuff that I'm aware...

Now what about adding a power valve..?? ..u could put it into the exhaust like the yamaha EXUP system in the yzf 4 stroke road bikes....pretty easy to do..

Ill also add that the air cooled top end came into its own when my mate opened it up and caught him of guard ..he frantically hit tge brakes low siding the bike at considerable speed..he was ok and so was the bike..but radiators would have taken a direct blow if they were still there..the thing...

Well now for the verdict.. I spent the last week in on the bike the riding was a good combination mostly tight technical first gear stuff along with some slippery hill climbing and a bit of open plain stuff..but still barely enough room to wind out 3rd gear. And all next to a buddy on a pretty...

Yeah..we got dt230 but they are no where near as common and much more expensive.2 -3 times what u can buy a dt200r for.. i had looked for a cheapish one for ages. They are a lil more complicated too electric start traction control and a nikasil bore, which is a big hassle here as if something...

At bike has gone a few transformations..including a motard set up using a complete rear end off a yamaha fzr250 and a fzr front wheel in stock forks.. but i have put the dirt wheels and suspension back on as its much more fun off road..the bike is just on 100kg and makes more power than the...

Bike

And another

Her are some pics

I started a thread about the possibilities of a crank case inducted blaster using a dt200r motor, basically tye same as a wr200.. i had no response or input. But i went ahead and built it using a vito big bore top end . Basically i cut off the blaster intake and filled it with liquid metal , i...

Really?....on a full blaster forum no one can give me this info? Is it because i spelt surface wrong..lol

Hi guys i dont have access to a blaster cylinder. im wanting the measurement from top to bottom of the cylinder machined faces..ie head gasket to bace gasket serfaces..it would handy if it were in millimeters thanks

Hi guys im in australia and run a custom lil 1997 dt200r, thats the crank case inducted one like wr200. Its used for mostly road riding and commuting with 17inch road wheels then i swap wheels over when i want to get dirty..they are a great lil engine butter smooth and make great usable power...

Hi guys i havnt been on here for a long time.. im in australia..wr200 and dt200R are very similar engine wise both engine cases are the same, dt200r steel liner wr200 plated, wr has bigger transfer ports and intake and no oil pump..the biggest differencec was in the bike its self..chasis...