Recent content by PirateBiker

I installed a 32mm flat slide and used the stock boots, just heated them with a heat gun and I was able to fit the carb in. The jetting that came with the carb was perfect with the FMF Fatty Gold and the twin air filter. You will probably have to play with your jetting. Start off rich and work...

'04 Honda 480R 480 big bore Hotcam Stage II Port & polished head Full Yoshimura exhaust Open airbox

The problem here is that you didn't rejet after putting on the FMF system. You were probably running lean and you did top end damage. Time to pull the head and jug and take a look, it's pretty easy to do.

But if powder coating chips, you can't just touch it up.

Hi, I was told you may be able to help me. I have a 1989 Blaster I am upgrading for my daughter-in-law. I have a Banshee axle but when I install it, it seems to be off center about 1.5 inches to the left side of the quad. I am using the Banshee brake hub. The Blaster axle appears to have a...

I have the Banshee brake hub.

I have a 1989 Blaster that I am fixing up for my daughter-in-law. I have a Banshee axle to install in it as I have read that they will install in the carrier, when I install it, it seems to be off center, the axle seems to be sticking about an inch and half further out to the left than to the...