Recent content by Mariusz

  1. M

    2002 Blaster rebuild

    sprockets look good and straight
  2. M

    2002 Blaster rebuild

    I got just a chain , quad came without a chain when I got it
  3. M

    2002 Blaster rebuild

    ok I have a question , orders a chain on ebay for a blaster 92 links , for some reason after I maxed out the adjustment its still loose , I think there are missing rollers
  4. M

    2002 Blaster rebuild

    do you know is rottela t good , I always used it for all my bikes with wet clutches
  5. M

    2002 Blaster rebuild

    Got the whole blaster back together , starts 2nd or 3rd kick still lags at low end mixture screw is off a little , ordered new chain and sprockets , have to change transition oil looked it up and it seems that a .75 quart is enough .
  6. M

    Adjusting Your Airscrew/Pilot Jet

    nicely explained !
  7. M

    2002 Blaster rebuild

    took the reeds out today , they looks good as far as I can tell , put the mixture screw at 1.5 turns out started a lot easier took good 4 or 5 kicks , it ran good throttle response a little late at low end , but its running
  8. M

    2002 Blaster rebuild

    I don't know much about reeds but will take a look , and I will check timing
  9. M

    2002 Blaster rebuild

    if I can sell it I will , I have a white 2004 blaster also , l have too many toys as it is .
  10. M

    2002 Blaster rebuild

    thanks for the info , I know my way around mechanical stuff but this is my first two stroke , took the carb apart again carb is spotless jets are clean , i mixed gas with oil at more 40:1 , dint want to fry the rings on first run maybe that's what causing hard starts , but when i started it...
  11. M

    2002 Blaster rebuild

    well today I had a very hard time starting the quad , took the carburetor apart cleaned it , it back fires a lot , and still hard to start , going to read up abut the carburetors .
  12. M

    2002 Blaster rebuild

    here is an update
  13. M

    2002 Blaster rebuild

    I got a 2002 Yamaha Blaster for $100 had low compression and it was missing few parts , need axle bolts , clutch cable , chain , don't know if oil block off was installed , and rear breaks don't work , had a cylinder honed and cleaned , ordered piston kit namura .060 over with gaskets . Here is...
  14. M

    need help with piston size

    well either way I ordered the extra gasket , thanks for everyone's input .
  15. M

    need help with piston size

    thanks for the info I ordered the namura kit and got a cometic gasket , hopefully the swap will go with no problems , also have to do the rear breaks fix (its a 2002 blaster ) and look into oil pump bypass , quad does not have a oil tank in the back but does not have a block off kit